Questions? 1-888-354-BIKE email

Rock The Bike

Climbing up El Arbol for the first ride

Rode El Arbol down the block with a pvc pipe instead of pedals. by you.

My dad’s been suggesting that I test ride El Arbol as soon as possible before sinking the hours into custom fiberglass work on the trunk, roots and branches. Not a bad idea.   OK, so it didn’t have brakes or pedals, but at least now the frame has at lease now been heat treated.

The ride was great. Tall bike people know that a tall object can actually be easier to balance. The classic example: try balancing a ruler in your palm, then try a yard stick. As you can see in the photo below, El Arbol is about a foot taller than Jay’s tall bike, part of his BayView Space Agency fleet. This makes it easier to balance at slow speeds.

El Arbol scale comparison to Bayview Space Agency patrol bike. by you.

On my first coast, I mounted using the hood of a pickup truck and had Ydran and Adam give a running push in the slightly downhill direction on Channing. The ride is solid. No noticeable frame flex, and that’s before the added stiffness of the fiberglass trunk and branch. The balance was easy, even at slow speeds. I only one little adrenaline jolt on the whole test ride, when I took a roundabout and experienced rapid decellaration. By the end I was doing my own running starts and dismounts in both the uphill and downhill directions. It was Adam’s idea to jam some pipe in the captain’s bottom bracket. That was hope stepped up and down onto the frame, as you can see above.

I had been a bit concerned that the small wheels that originally came with the A2B would make the ride twitchy or sluggish, but it was neither. The traction was great, ans slow speed manuevers felt smooth.

I knew that Jay was leaving for his honeymoon yesterday, and that Tuesday would be our last work session. We welded in the cable management for the root-deployment system. I’ll post more photos soon.

Roots of El Arbol serving their role in stabilizing the rig for welding. by you.

On Wednesday I borrowed a truck to get the frame over to Garner Heat Treating in Oakand. The guys were totally pro and enthusiastic about the project.

El Arbol frame ready to go in the oven at Garner Heat Treating, Oakland. by you.

Apparently there are two ways to restore strength to an aluminum frame after it’s been welded. The more involved one heats the frame to within 30 degrees of liquid, which leaves the frame soft and succeptible to bending under its own weight. Typically at this point bike builders put the frame back in a jig to check alignment. Because El Arbol is a giant frame and a one off, there’s no jig. So we chose the other method, which brings up the frame only to about 300-400 degrees. This method stress relieves the welds but not to the full ‘T6’ strength of the aluminum. With the average wall thickness of El Arbol’s frame being much greater than that of say a Cannondale, I’m not too worried about the strength being compromised.

After bringing the frame back to Rock The Bike, I waited till about 6 last night before ditching the computer and throwing parts back on it. We tied the roots against the frame, since the deployment system isn’t ready yet, and I through an Envy Green Down Low Glow on the bottom tube. Lots of props from the neighborhood, a good omen!